SH-P1 Training
110
Slide 110
2. Energy Saving
2.2 Energy Saver Mode: Sleep Mode – 3
The machine recovers to the ready condition:
If the operation switch is pressed
» The operation panel lights. When warm-up is finished, the machine
goes to the ready condition.
» Then, after the job is completed, the machine returns to sleep mode
(via ready mode) when the auto off timer runs out or the operation
switch is pressed.
» This is the same as Off mode.
Power
Consumption
Warm-up
Operation Mode
Ready Mode
Sleep Mode
Plug In
Time
Operation Switch is
pressed
Warm-up
Operation Mode
Ready Mode
Sleep Mode
This timing chart shows what happens if the operation switch is pressed while
the machine in sleep mode.
Power consumption during warm-up may be much higher than shown in this
diagram.
To Next Page
Loading...
Need help?
General