Printing Suspended
Printing is suspended. Turn off the printer, and turn it on again to recover.
Ready
This is the default ready message. The printer is ready for use. No action is required.
Remote Diagnostics
The printer is performing diagnostic tests remotely.
Resetting Job...
The printer is resetting jobs. Wait a while.
Setting change...
The printer is changing settings. Wait a while.
Set the Fusing Unit correctly.
The fusing unit may not be installed correctly. Turn the printer off and re-install the fusing unit.
If the message is still displayed after re-installation, contact your sales or service representative.
See p.161 "Replacing the Fusing Unit, Transfer Roller, and Dustproof Filter" for fusing unit installation.
SmartServ.Call
The printer is contacting the Smart Service center. Some or all of the printer's functions may not be available.
Updating Certificate...
The printer is updating @Remote certificate.
Waiting for print data...
The printer is waiting for the next data to print. Wait a while.
Alert Messages (in alphabetical order)
@Remote Cert. update failed
Updating the @Remote certificate failed. Contact your sales or service representative.
@Remote error. Call service
There was an error with the @Remote line.
Add staples.
The finisher unit is out of staples. Add more staples, or print again without using the staple function.
Add staples and empty the punch receptacle
The finisher is out of staples, and the punch receptacle is full. Add more staples and empty the punch
receptacle.
9. Troubleshooting
198
To Next Page
Loading...
Need help?
General