Add toner<K,C,M,Y>
The printer has run out of the indicated toner. Replace the indicated toner cartridge. See p.139 "Adding
Toner".
Cannot connect=>Comm.Serv.
There was a communication error in the remote service modem.
Cannot connect=>Comm.Serv./ Check proxy user/password.
The proxy user name or password is incorrect. Check the proxy server settings, and change the user name
and/or password if they are incorrect.
Netwrk connection failed./ Check IP Address.
The connection with the network has failed. Check that the IP address is correct.
Netwrk connection failed./ Contact the administrator.
The connection with the network failed. Contact the network administrator.
Netwrk connection failed./ Please call service.
The connection to the network failed.
Cannot connect with DHCP (101/201)
Cannot obtain IP address from DHCP server. Contact the network administrator.
Cannot connect with/ NetWare print server. (107/207)
Connection with NetWare print server is unavailable. Contact the network administrator.
Cannot connect with/ NetWare server.(106/206)
Connection with NetWare server is unavailable. Contact your network administrator.
Cannot print.
Check the file you want to print is a supported file type. Check for misfeeds and ask your network
administrator for help.
Cannot recognize SDRAM mod./ Please call service.
The printer could not recognize the installed optional memory.
Cannot set IPv4 within/ the same subnet range. (###)
The IPv4 address cannot be set within the same subnet ranges.
Change (tray name) to the following settings: A4 (Recycled)
The specified paper type is different from the paper type in the indicated tray. This message does not apply
to the bypass tray. Press [Change] to change the tray's settings, press [Job Reset] to reset the job, or press
[FormFeed] to force printing.
Error and Status Messages that Appear on the Control Panel
199
To Next Page
Loading...
Need help?
General