Ricoh B064 - Docking to the Finisher

Z-FOLDING UNIT B660
B064 Series/B140 Series/G126 1-78 SM
Docking to the Finisher
1. Remove the back cover of the finisher ( x 2).
2. Attach the left docking bracket [A] to the Z-folding unit ( x 2) (Bracket
provided with the finisher).
3. Attach the right docking bracket [B] to the Z-folding unit ( x 2). (Bracket
provided with the finisher).
4. Attach the rear locking bracket ( x 2).
• Attach rear bracket [C] if the cover interposer tray is installed.
• Attach rear bracket [D] if cover interposer tray is not
installed.
5. Attach the front locking bracket ( x 2).
NOTE: This step is required only when the Z-folding unit is installed with the
B674 (SR861).
• Attach front bracket [E] if the cover sheet interposer is installed.
• Attach front bracket [F] if the cover sheet interposer is not
installed.
6. Attach the ground plate [G] to the Z-folding unit ( x 2).
B660I004.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]