SERVICE PROGRAM MODE TABLES
B064 Series/B140 Series/G126 5-66 SM
SP5xxx Mode
5023* Punch Type Display Selection
011 Punch Type Display Selection
023 Priority Punch Position
5024* mm/inch Display Selection
Selects the unit of measurement.
After selection, turn the main power switch off and on.
[0~1/1]
0: mm
1: inch
5037 Status Lamp Detection
Enables or disables the function of the status lamp installed above the operation
panel.
[0~1/1]
0: Off: Disabled
1: On: Enabled
This status lamp requires special ordering and installation for this machine.
5044 Operation Panel Bit SW
001 SW1
002 SW2
5045 Counter Method Japan Only
5047 Reverse Paper Display
Determines whether the tray loaded with paper printed on one side is displayed.
[0~1/1]
0: Not displayed
1: Displayed
5051 Toner Refill Detection Display Japan Only
5104* A3/DLT Double Count
Specifies whether the counter is doubled for
A3/11"x17" paper.
[0~1/0/1]
0: No
1: Yes
If "1" is selected, the total counter and the
current user code counter count up twice
when A3/11"x17" paper is used.
To Next Page
Loading...
