Ricoh B064 - Inverter Exit Sensor, Transport Sensors 1 & 2

DUPLEX UNIT
SM 3-91 B064 Series/B140 Series/G126
Replacement
Adjustment
3.10.8 INVERTER EXIT SENSOR, TRANSPORT SENSORS 1 & 2
[A]: Cross-stay ( x 4)
[B]: Reverse trigger roller shaft
[C]: Jogger fences ( x 1 each)
[D]: Left half of table ( x 2)
• The front screw is a shoulder screw. Insert the screws in the correct holes
when re-attaching.
• To avoid breaking the tabs under the left edge of the table, pull the table to
the right to disengage the tabs and then remove.
[E]: Inverter exit sensor ( x 1, harness x 1,  x 1)
[F]: Transport sensor 1 (harness x 1,  x 1)
[G]: Transport sensor 2 (harness x 1,  x 1)
B140R817.WMF
B140R818.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]