MFP OPTIONS: B140 SERIES
SM 1-115 B064 Series/B140 Series/G126
Installation
Installation Procedure
CAUTION
The machine should always be turned off and its power cord disconnected
before you do any of these procedures.
NOTE: If the machine has the PostScript option, refer to “SD Card Application
Move” (Section 5.5)
1. If the machine is on, turn the main power switch OFF.
2. If the NIB is installed, disconnect the network cable.
3. Remove the slot cover [A] ( x 2).
4. Put the SD card [B] in the slot.
5. If the NIB is installed, connect the network cable.
6. Turn the main power switch ON.
7. Do SP5878 (Option Setup).
8. Exit SP mode.
9. Turn the operation switch OFF, and then turn the main power switch OFF.
10. Turn the main power switch ON.
11. Turn “Auto Erase Memory Setting” ON:
User Tools >> System Settings >> Administrator Tools >> Auto Erase Memory
Setting >> ON
[B]
[A]
Rev. 05/2005
⇒
To Next Page
Loading...
