MAIN MACHINE (G126)
SM 1-121 B064 Series/B140 Series/G126
Installation
5. Remove the face plate [E] of the
development unit (1 knob, 2 screws).
6. Disconnect the development unit [F]
(2 connectors).
NOTE: If the LCT is installed, you may
need to disconnect it so the front
door can open far enough to
allow removal of the
development unit.
7. Close the supply pipe shutter [G], and
then while allowing the development unit
[H] to slip to the right, slowly pull it out of
the machine.
8. Remove the toner hopper [A] (2
screws).
9. Rotate the toner hopper [B] slightly
10° to 20° as you slide it up to
remove it.
B064I302.WMF
B064I303.WMF
B064I304.WMF
[G]
[H]
[F]
[B]
[A]
[E]
Rev. 05/2005
To Next Page
Loading...
