Ricoh B064 - Page 159

MAIN MACHINE (G126)
SM 1-125 B064 Series/B140 Series/G126
Installation
6. Remove the tray cover [A] (2 screws).
7. Remove the motor cover [B] (4
screws).
8. Re-position the side fences [C] (8
screws). The outer slot position is
used when loading A4 size paper.
9. Re-install the motor cover and the tray
cover.
10. Remove the rear bottom plate [D]
(1 screw).
11. Re-position the return position sensor
bracket [E] (1 screw). To use the
paper tray for A4 size, put the screw in
the left hole as shown. (For LT size,
the screw should be placed on the
right.)
12. Re-install the rear bottom plate.
13. Change the paper size using SP5959-
001 (Paper Size – Tray 1).
B064I566.WMF
B064I523.WMF
B064I024.WMF
[D]
[E]
[A]
[B]
[C]
Rev. 05/2005