SOFTWARE UPDATE
SM 5-15 B064 Series/B140 Series/G126
Service
Tables
Doing the Software Update Procedure
An SD card with the software downloaded to
it is necessary for this procedure.
1. Turn the main switch off.
2. Remove the SD card slot cover from the
controller.
3. Hold the SD card [A] (the surface with
printing must be away from the front of
the machine), and install the SD card in
slot C3 [B].
4. Turn the main power switch on.
5. Stop until the version update screen is displayed. If the SD card contains more
than one software application, the screen will be almost the same as the one
below. The screen below shows that the SC card contains two applications:
“Engine” and “Printer”.
B140S908.WMF
PCcard -> ROM Page01
Exit(0)
Engine(1)
Printer(2)
ROM: XXXXXXX
ROM: X.XX
ROM: XXXXXXX
ROM: X.XX
NEW: XXXXXXX
NEW: X.XX
NEW: XXXXXXX
NEW: X.XX
B140S901.WMF
[A]
[B]
To Next Page
Loading...
