Ricoh B064 - Page 450

SERVICE PROGRAM MODE TABLES
B064 Series/B140 Series/G126 5-48 SM
2935* Transfer Current On/Off Timing (Tray 4) (Japan Only)
001 La1 Adjusts on transfer current ON timing for front side copying.
[–30~+30/1 mm]
002 La1f
Adjusts the area where transfer current is applied for the
leading edge during front side copying.
[0~+20/1 mm]
003 Lc1r
Adjusts the area where transfer current is applied for the
trailing edge during front side copying.
[0~+20/1 mm]
004 Lc1
Adjusts the transfer current OFF timing for front side
copying.
[–30~+30/1 mm]
005 La2 Adjusts on transfer current ON timing for back side copying.
[–30~+30/1 mm]
006 La2f DFU
Adjusts the area where transfer current is applied for the
leading edge during backside copying.
[0~+20/1 mm]
007 Lc2r
Adjusts the area where transfer current is applied for the
trailing edge during back side copying.
[0~+20/1 mm]
008 Lc2
Adjusts the transfer current OFF timing for back side
copying.
[–30~+30/1 mm]
009 La3
Adjusts the transfer current ON timing for copying thick
paper.
[–30~+30/1 mm]
010 La3f
Adjusts the transfer current OFF timing for the leading edge
length when copying thick paper.
[0~20/1 mm]
011 Lc3r
Adjusts the transfer current ON timing for the trailing edge
length when copying with thick paper from the LCT.
[0~20/1 mm]
012 Lc3
Adjusts the transfer current OFF timing for copying with thick
paper from the LCT.
[–30~+30/1 mm]