SERVICE PROGRAM MODE TABLES
B064 Series/B140 Series/G126 5-102 SM
6105* Staple Position Adjustment
Adjusts the stapling position in the main scan direction.
[–3.5~+3.5/0.5 mm]
A larger value shifts the stapling position outward.
6107* Finisher Free Run (B478/B706 only)
Selects the free run mode during testing.
001 Stapling Mode
Stapling only
002 All Mode
All finisher operation is tested
003 Packing Mode
Before you move the finisher to a new location, do
this SP. When you switch on the machine after you
moved it, the finisher automatically goes to the
ready condition.
004 Shift Mode
Tests the shift mode
6113* Punch Hole Adjustment
001 2-Holes
Adjusts the punch hole position in the sub-scan direction for the punch unit with
two punch holes.
[–7.5~+7.5/0.5 mm]
A larger value shifts the punch holes towards the edge of the paper.
002 3-Holes
Adjusts the punch hole position in the sub-scan direction for the punch unit with
three punch holes.
[–7.5~+7.5/0.5 mm]
A larger value shifts the punch holes towards the edge of the paper.
6116* Staple Limit Counter for Thick Paper
Multiply the normal limit by this number to determine the staple limit number for
thick paper.
[1~3/1 sheet]
6117 Finisher Input Check
Displays the signals received from sensors and switches
of the finisher. ( 5.7.5)
001 INPUT1
002 INPUT2
INPUT3
003
004
INPUT4
005 INPUT5
006 INPUT6
6118 Finisher Output Check
Turn on the electrical components of the finisher
individually for test purposes. ( 5.7.6)
6119* Punch Function Enabled (Thick Paper)
Allows punching heavier paper, including tab sheets.
[0~1/1]
0: Punching thick paper prohibited
1: Punching thick paper allowed
To Next Page
Loading...
