SERVICE PROGRAM MODE TABLES
SM 5-105 B064 Series/B140 Series/G126
Service
Tables
6900* ADF Up/Down Setting
Sets the timing for raising and lowering the bottom plate of the ADF.
[0~1/1]
0: Original set
1: Copy start
6902* Fold Position Adjustment
Adjusts the fold position of the copies for saddle-stitching according to paper size
for multiple sheets. The amount of folding skew for single and multiple sheets is
different. This SP adjusts for multiple sheets. SP6903 adjusts for single sheets.
Note (B140 only): Always set SP6902 first and then set SP6903. If the order is
reversed, the value of SP6902 is added to SP6903. This causes the folding
position to shift for single-sheets and causes the booklet to skew.
001 A3 [–3.5~+3.5/0.5 mm]
002 B4
003 A4T (SEF)
004 B5T (SEF)
005 DLT (B140 only)
006 LG
007 LTT (SEF)
008 Others
6903* Fold Position Adjustment (1 Sheet) (B140 only)
Adjusts the fold position for single sheets to minimize vertical skew. The amount
of folding skew for single and multiple sheets is different. This SP adjusts for single
sheets. SP6902 adjusts for multiple sheets.
Note: Always set SP6902 first and then set SP6903. If the order is reversed, the
value of SP6902 is added to SP6903. This causes the folding position to shift for
single-sheets and causes the booklet to skew.
001 A3
002 B4
003 A4T (SEF)
004 B5T (SEF)
005 DLT
006 LG
007 LTT (SEF)
008 Others
[-7.5~+7.5/0.5 mm]
A higher value brings the fold closer to the trailing edge; a lower
value moves it away from the trailing edge.
6904 Punch Function Enabled (Z-Fold) (B140 only)
Switches on the hole punch for use when the machine operates with the Z-fold
unit.
[0~1/1]
0: No punching with Z-fold unit operation
1: Punching allowed with Z-fold unit operation
To Next Page
Loading...
