Ricoh B064 - Page 62

LG/B4 FEEDER KIT (B474)
B064 Series/B140 Series/G126 1-28 SM
5. Remove the LCT cover [A] ( x 1).
6. Remove the right stay [B] and re-
attach it below ( x 2).
7. Remove the right cover [C] ( x 2).
8. Attach the front bracket [D] with the
beveled corner down ( x 2).
NOTE: If the brackets are difficult to
install, raise the bottom plate with
your hand.
9. Attach the rear bracket [E] with the
beveled corner down ( x 2).
10. Attach the bottom plate extension [F]
with the hex nuts ( x 4).
11. Align the positioning pin [G].
12. Attach the B4/LG frame [H] with the
hex nuts ( x 2).
The kit is set for B4. If you need to
change the paper size to LG, do the
following steps.
B474I001.WMF
B474I502.WMF
B474I553.WMF
[H]
[G]
[D]
[E]
[F]
[A]
[C]
[B]