EasyManua.ls Logo

Ricoh C230 - Maintaining Your Machine; Cleaning the Machine; Cleaning the Exposure Glass; Cleaning the Auto Document Feeder

Ricoh C230
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintaining Your Machine
If
the exposure glass or scanning glass is dirty, copy clarity may be reduced. Clean these parts if they are
dirty.
Do
not use chemical cleaners or organic solvents, such as thinner or benzene. If such substances get
inside the machine or melt plastic parts, a failure might occur.
Do not clean parts other than those explicitly specified in this manual. Other parts should only be
cleaned by your service representative.
Cleaning the Machine
This section describes how to clean the machine.
Wipe the machine with a soft, dry cloth. If this does not remove the dirt, wipe the machine with a damp
and
tightly wrung cloth. If a damp cloth still does not remove the dirt, try using a mild detergent. Wipe the
machine with a dry cloth to remove the moisture, after using a damp cloth.
Cleaning the Exposure Glass
This section describes how to clean the exposure glass and the scanning glass.
1. Wipe the exposure glass and the scanning glass.
CCS020
12
1. Scanning glass
2.
Exposure glass
Cleaning the Auto Document Feeder
This section describes how to clean the ADF.
7. Remarks
122
7

Table of Contents

Related product manuals