1. Carefully pull out tray 1 until it stops.
2. Square the paper and load it print side up.
Do not stack paper over the limit mark.
3. Carefully push tray 1 fully in.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Various sizes of paper can be loaded in trays 1 4 by adjusting the positions of side fences and end
fence. For details, see “Changing the Paper Size in Trays 1 4”.
• You can load envelopes in trays 1 4. For details about how to load envelopes, see “Changing the
Paper Size in Trays 1 4”. For details about various details about and recommendations concerning
envelopes, see “Envelopes”.
• Each tray can hold up to 550 sheets.
• p.80 "Changing the Paper Size in Trays 1 - 4"
•
p.83 "Changing to a Size That Is Not Automatically Detected"
• p.94 "Envelopes"
3. Adding Paper
78
To Next Page
Loading...
