Bit Switch 13
BIT FUNCTION
DATA
COMMENTS
0
Not used
Do not change the factory settings.
1
2
Not used
Do not change the factory setting.
3
Halftone dither
0: 64 level matrix
The software contains two different dither matrixes for halftone
matrix
1: 16 level matrix processing. This bit determines which one is used.
4
Smoothing of 0: Disabled If this is 1, faxes received in standard mode will be smoothed
received images
1: Enabled
to detail mode before printout. Faxes received in detail mode
will be smoothed to fine mode if the tx side indicates that the
message was scanned using fine mode, even if this bit is 0.
5
Near-end indication 0: Enabled
The machine tells how much paper is left on a roll by counting
1: Disabled how much paper is used up. When 90% of the roll has been
used, the Replace Paper indicator blinks to warn the user that
the roll is almost empty. If this bit is 1, this function is disabled.
6
Action when copy
0: Machine stops for 40 Continuous copying could cause thermal head burnout, so
count reaches 30 s after every page
this bit should be kept at 0. This bit is not effective for recep-
in copy mode 1: Machine continues
tion.
copying normally
7
Result report
0: Enabled 0: A Polling File List or Memory Transmission Report is printed
1: Disabled whether the communication was successful or not.
1: When polling or memory transmission has been completed
successfully, no Polling File List or Memory Transmission
Report is printed. However, the report is printed if the com-
munication failed.
2-63
To Next Page
Loading...
