Bit Switch 14
BIT
FUNCTION
DATA
COMMENTS
0
New file report prin- 0: Enabled
This report gives information about the file just stored, for the
tout after storing
1: Disabled
user’s reference.
1
Printout of image
0: Enabled
0: A sample of the message sent from memory can be printed
data sample on 1: Disabled
at the bottom of the error report as a reference if transmission
error reports for
failed. This bit is ignored if bit 1 of bit switch B is 1.
failed memory
transmissions
2
Action when rx er-
rors occur during
memory reception
(if PIN or RTN were
received)
3
Multicopy mode
(FAX85 only)
0: Data is erased
0: If there are errors during memory reception, the message
1: Data is kept will be erased from the memory, and the user will have to ask
the sender to resend the message.
1: If there are errors during memory reception, the message
will be stored in memory, complete with errors.
0: Disabled If this bit is at 0, Function 77 cannot be used.
1: Enabled
4
Not used
Do not change the factory setting.
5
Erasing incoming
0: Yes 1: No
Fax messages are stored into memory at the same time as
fax messages from
printing so that data will not be lost if a printer fault develops
memory immedi-
during printing
ately after printing If this bit is 0, the message will be automatically cleared from
memory immediately after printing.
If this bit is 1, the message will not be cleared from memory;
the user must clear the message using Function 67.
Continued on the next page.
2-64
To Next Page
Loading...
