Ricoh G-P3 - Page 119

SC
[Level]
Symptom Possible Cause/Required Action
[B]
The USB interface cannot be
used due to a driver error.
• Defective USB driver
• Loose connection
1. Check the connection.
2. Replace the controller.
860
[B]
HDD: Initialization error
The controller detects that the
hard disk fails.
• HDD not initialized
• Defective HDD
1. Reformat the HDD (SP5832).
2. Replace the HDD.
861
[D]
HDD: Reboot error
The HDD does not become
ready within 30 seconds after
the power is supplied to the
HDD.
• Loose connection
• Defective cables
• Defective HDD
• Defective controller
1. Check the connection between the HDD and
controller.
2. Check and replace the cables.
3. Replace the HDD.
4. Replace the controller.
863
[D]
HDD: Read error
The data stored in the HDD
cannot be read correctly.
• Defective HDD
• Defective controller
1. Replace the HDD.
2. Replace the controller.
864
[D]
HDD: CRC error
While reading data from the
HDD or storing data in the
HDD, data transmission fails.
• Defective HDD
1. Replace the HDD.
865
HDD: Access error
4. Troubleshooting
118
4