Ricoh G-P3 - Page 158

1004 072
[-4.00 to 4.00 / 1.05 / 0.01%/step]
Fusing: RS: Thin *EGB
1004 073 Trans. Belt: LS: TN *EGB
Adjusts the transfer belt motor speed.
[-4.00 to 4.00 / 0.0 / 0.01%/step]
1004 074 Trans. Belt: RS: TN *EGB
1004 075 PFU: LS: Thin *EGB Adjusts the speed of the feed motor in the
optional paper tray unit.
[-4.00 to 4.00 / -0.36 / 0.01%/step]
1004 076 PFU: RS: Thin *EGB
1004 077 Duplex: LS: Thin *EGB
Adjusts the duplex motor speed.
[-4.00 to 4.00 / -0.36 / 0.01%/step]
1004 078 Duplex: RS: Thin *EGB
1004 079 DEV / OPC [K]: LS: OHP *EGB
Adjusts the black development and OPC motor
speed.
[-4.00 to 4.00 / -1.35 / 0.01 %/step]
1004 080 DEV [CMY]: LS: OHP *EGB
Adjusts the color development motor speed.
[-4.00 to 4.00 / 0.0 / 0.01%/step]
1004 081 OPC [CMY]: LS: OHP *EGB
Adjusts the color OPC motor speed.
[-4.00 to 4.00 / -1.35 / 0.01%/step]
1004 082 Fusing: LS: OHP *EGB
Adjusts the paper exit and fusing motor speed.
[-4.00 to 4.00 / 0.6 / 0.01%/step]
1004 083 T.Belt: LS: OHP *EGB
Adjusts the transfer belt motor speed.
[-4.00 to 4.00 / 0.0 / 0.01%/step]
1004 084 PFU: LS: OHP *EGB
Adjusts the speed of the feed motor in the
optional paper tray unit.
[-4.00 to 4.00 / -1.14 / 0.01%/step]
1004 085 Duplex: LS: OHP *EGB
Adjusts the duplex motor speed.
[-4.00 to 4.00 / -0.36 / 0.01%/step]
1006 [Phase Adjust.] Phase Adjustment
1006 001 Angle *EGB
Adjusts the phase angle between the K drum and
the CMY drums.
[-180 to 180 / 0 / 1deg/step] DFU
Service Mode Table
157
5