1104 [Fusing Cont.] Fusing Control
1104 001
Control Method *EGB [0 or 1 / 1 / -]
Selects the fusing control method.
0: ON/OFF Control, 1: PID Control (Phase control)
1104 022
Max. Wait Time *EGB [0 to 255 / 30 / 1 sec/step]
Adjusts the maximum waiting time for the target printing temperature of fusing unit. After
this interval, printing will start if the temperature did not get to the target.
1104 023
Paper Feed. Temp. *EGB [0 to 30 / 10 / 1deg /step]
Adjusts the increase in the temperature of the fusing unit between the ready condition and
the start of paper feed at the start of a new job.
1104 024
1st Add Time: LS [0 to 50 / 0 / 0.1 sec/step]
For print jobs at low speed. If the interval between jobs is less than this setting, then the
temperature change (1104 025) for the first page of a new job is not applied.
1104 025
1st Add Temp. *EGB [0 to 20 / 8 / 1deg /step]
Adds this value to the basic fusing temperature, for the first page of a new job. This extra
temperature is necessary because when the printer starts the first page, the fusing unit is
not warm enough.
1104 026
1st Temp. Maint. *EGB [0 to 50 / 8 / 1 sec/step]
Adjusts the time for maintaining the temperature change that is set with 1104 025.
1104 027
1st Print Inter. *EGB [0 to 100 / 0 / 0.1 sec/step]
For print jobs at regular speed. If the interval between jobs is less than this setting, then
the temperature change (1104 025) for the first page of a new job is not applied.
1104 028
Paper Feed. Temp. *EGB [0 to 30 / 5 / 0.1 deg/step]
Adjusts the increase in the temperature of the fusing unit between the ready condition and
the start of paper feed at the start of a new job (B/W mode).
1104 029
1st PrtDecTmpTime *EGB [0 to 255 / 3 / 1 sec/step]
Adjusts the time for decreasing 1°C when the temperature decline to the target printing
temperature.
1104 030
PreRot.Thre.Temp. *EGB [0 to 255 / 20 / 1 deg/step]
5. Service Tables
158
To Next Page
Loading...
