Ricoh G-P3 - Page 187

2306 002 Correction Coef. *EGB
Adjusts the Vd link correction coefficient.
[1.00 to 2.50 / 1.00 / 0.01/step]
2314 [Trans.Belt Bias] Transfer Belt Current at Process Control
2314 011 Process Cont. [K] *EGB
Adjusts the transfer belt current at process control
for [K].
[0 to 60 / 13.0 / 0.1 µA /step]
2314 012 Process Cont. [M] *EGB Adjusts the transfer belt current at process control
for [M, C].
[0 to 60 / 10.0 / 0.1 µA /step]
2314 013 Process Cont. [C] *EGB
2314 014 Process Cont. [Y] *EGB
Adjusts the transfer belt current at process control
for [Y].
[0 to 60 / 13.0 / 0.1 µA /step]
2326
[T.Roll2 Clean.] Transfer Roller Cleaning
(Positive or Negative Bias, Process Speed) Process Speed -> RS: Regular speed, LS: Low
speed
2326 002 Posi. Bias: RS *EGB Adjusts the positive voltage for transfer roller
cleaning.
[0 to 2 / 2.0 / 0.1 KV/step]
2326 003 Posi. Bias: LS *EGB
2326 005 Nega. Bias: RS *EGB Adjusts the negative voltage for transfer roller
cleaning.
[0 to 60 / 60.0 / 0.1V/step]
2326 006 Nega. Bias: LS *EGB
2352
[Trans.Belt Bias] Transfer Belt Current
([Color], Process Speed) Process Speed -> RS: Regular speed
2352 001 [K]: RS
Adjusts the current that is applied to the transfer belt.
[0 to 60 / 17.0 / 0.1 µA /step]
2353
[Trans.Belt Bias] Transfer Belt Current
([Color], Process Speed) Process Speed -> LS: Low speed
2353 001 [K]: LS *EGB Adjusts the current that is applied to the transfer belt.
5. Service Tables
186
5