5. Arrange and load a stack of new paper into the tray with the print side up. Make sure that there is no
gap between the paper and the paper guides. Adjust the paper guides to close gaps if necessary.
6. Lift the front of paper tray 1, and slowly slide the paper tray back until it stops. Make sure that the
paper tray is fully inserted, to prevent paper jams.
Turning Power on
• Turn off the power switch whenever you plug in and unplug the power cord.
1. Make sure that the power switch is set to "" (Off).
2. Plug in the machine.
1. Installation Procedure
26
To Next Page
Loading...
