Interrupting the Current Copy to Copy Another Original
When [Interrupt] is displayed on the copy processing screen, you can pause the current
copy to scan and copy another original (Interrupt mode).
1. Press [Interrupt] on the execution screen of a copy job.
2. When the scanning stops, remove the original being copied.
3. Place a new original to scan on the machine.
page107”Basic Procedure for Copying Documents”
4. Specify 2 sided, Combine, Sort, and other copy settings if necessary.
page118”Duplex Copying”
page121”Combining and Copying a Multi-page Original onto a Single Sheet of Paper”
page127”Copying in Page Order or for Each Page Number”
5. Press [Interrupt Start].
6. When the Interrupt mode is finished, remove the original and copied paper.
7. Press [Cancel Interrupt].
8. If the scanning of the original was interrupted in Step 2, reset the rest of the original
onto the machine, and press [Start].
The previous copy job settings are restored. Simply press [Start] to continue copying
from where it left off.
• You cannot use the Interrupt mode while scanning a fax original.
• You cannot use the Interrupt mode with the staple mode while copying in the staple
mode.
• When the Booklet Finisher SR3330 or Booklet Finisher SR3350 is installed in the
machine, you cannot use the Interrupt mode while [Center Folding] is set when
copying using [Center Folding].
• When the internal multi-fold unit is installed in the machine, you cannot use the
Interrupt mode with the fold mode while copying in the multi-sheet fold mode.
To Next Page
Loading...
