3. Enter "ipconfig/all" and press the [Enter] key.
4. Check the host name, enable/disable status of the DHCP server and IP address, and
write down the information in [1] on the check sheet.
When the screen shown above is displayed, fill in the sheet as follow:
5. Enter "set user" and press the [Enter] key.
Enter a space between "set" and "user".
6. Check the domain name, workgroup name and login user name, and write down the
information in [2] on the check sheet.
When the screen shown above is displayed, fill in the sheet as follow:
"USERDNSDOMAIN" is not displayed when the login user who executed the
command is a local user.
To Next Page
Loading...
