6. Square the paper and load it with the print side facing up.
Fan sheets before loading so that multiple sheets of paper do not stick to each other
and are not fed at once.
Check the paper edges are aligned at the right side.
Do not stack paper over the limit mark.
7. While pressing the release lever, adjust the side and end fences to the paper size.
Do not leave spaces between the paper and fences.
To fix the end fence, engage the two projections of the stopper with the holes on the
end fence, and then tighten the fixing screw by rotating it 90 degrees clockwise with
a coin or similar object.
To Next Page
Loading...
