Check the ratio and
then press [Start]
again."
The paper size
specified in [Scan
Ratio] [Specify
Size] requires a
reduction value
smaller than 25%.
Specify a paper size for which a reduction
ratio greater than 25% is specified in
[Send Settings] [Scan Ratio]
[Specify Size].
"Programmed.
Cannot program the
destination(s) that
is not programmed
in the address
book."
A folder specified
by Manual Entry is
included among the
programmed
destinations.
Register the destination in the address
book of the machine, and then register it
to a program.
"Programmed.
Cannot program the
folder
destination(s) with
protection code(s)."
A destination
specified with a
protection code is
included among the
programmed
destinations.
• You cannot program a destination
specified with a protection code.
Specify this destination individually.
• To program this destination, cancel
the protection code and then register
the destination to a program.
See "Using the Protection Function to
Prevent the Misuse of Addresses",
User Guide (HTML).
"SMTP
authentication
email address and
administrator email
address mismatch."
The SMTP
authentication e-
mail address is not
registered in the
administrator e-
mail address.
Register the SMTP authentication e-mail
address in [Settings] [System Settings]
[Send (Email/Folder)] [Email]
[Administrator's Email Address].
"Some invalid
destination(s)
contained. Do you
want to select only
valid
destination(s)?"
The group contains
an e-mail address.
When sending data to a destination other
than an e-mail address, press [Yes].
"The program is
recalled. Cannot
recall the folder
destination(s) with
protection code(s)."
A folder destination
specified with a
protection code is
included among the
programmed
destinations.
• You cannot recall a destination
specified with a protection code in a
program. Specify this destination
individually.
To Next Page
Loading...
