Display Summary
J012/J013/J014 4-10 SM
Menu/Menu Item Function
Host I/F Settings?
1 I/O Timeout? Determines how long the machine waits for the interface to
respond. After the specified time elapses, the machine can
receive data from another interface. If the specified time is
too short, a timeout might occur while a data transfer is in
progress. If this occurs, the print job will be interrupted by a
new job from another interface.
Range: 10, 15, 20, 25, 60 sec.
Default: 15 sec.
2 USB Speed? Two settings are available:
Auto: 480 Mbps or 12 Mbps automatically adjusted
Full Speed: 12 Mbps fixed
Default: Auto
Normally, this setting does not require changing.
3 Fixed USB Port? Specifies communication settings for a USB connection.
On/Off
Default: Off
4 Auto Email Notif.? Determines whether a notification is sent to a specified
email address when a machine error occurs. Be sure to
cycle the machine off/on after doing this setting.
[On or Off/Off]
PCL Menu?
For more details, please refer to the User's Guide.
Note:
These settings are displayed for the J014 only.
The J012/J013 do not support PCL.
The settings take effect during PCL print jobs only.
To Next Page
Loading...
