Ricoh J014 - Page 190

SC Error Codes
J012/J013/J014 4-24 SM
950
USB Chip ID Detection Error
At power on there was a power surge
caused by unstable power supply.
 CTL board defective
951
USB Undefined Assignment Error
An undefined interrupt signal was
detected at the ID chip.
 CTL board defective
970 A
Flash ROM Erase Error
The device erasing the Flash ROM
generated an error.
 Flash ROM device defective.
971 A
Flash ROM Write Error
The device writing to the Flash ROM
generated an error.
 Flash ROM device defective.
972 A
Flash ROM Verify Error
The verify operation after write failed
(the data written to the Flash ROM did
not match the content of the data in
the Flash ROM).
 Flash ROM device defective.
973 A
EEPROM Write Error
An EEPROM write error was detected
at power on, or during a print job.
 The EEPROM device is
defective.
978 A
Ink Sump Full
The ink sump on the left side of the
printer is full.
Note: A software counter monitors the
usage of the ink sump. There are no
sensors associated with the ink
sump.
 Replace the ink sump.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA