Ricoh J014 - Page 191

SC Error Codes
SM 4-25 J012/J013/J014
Trouble-
shooting
979 A
Ink Supply Timeout
This error code is issued if full auto
cleaning is done before the bubbles
inside the print head are consumed
(within 72 hours after power on).
 Cycle the machine off/on
984 A
DRV Circuit Temperature Abnormal
The temperature of the DRV
board (driver board) is out of
range.
 The temperature of the DRV board
(driver board) circuit is not within the
specified range: -13°C to 55°C (11.2°F
to 131°F)
985 A
Print head Temperature Sensor Abnormal
Print head temperature
sensor was detected as
abnormal when the printer
was turned on.
 Print head temperature sensor was
detected as abnormal when the printer
was turned on without the product
number registered.
986 A
Humidity Sensor Abnormal
The printer detected that the
humidity sensor was
abnormal.
 Sensor connector loose, damaged, or
defective.
 Sensor defective
987 A
Protection During Transport
At power on the printer
detected that the ink in a
cartridge is non-standard
ink.
 Use only ink cartridges that are
designed for use with this printer.
 Never use re-filled ink cartridges.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA