Quick Reference
SM 4-65 J012/J013/J014
Trouble-
shooting
Registration 1. [Menu]> "System Settings?"
2. [#] or [%] > "Maintenance?" > [Yes]> "1 Nozzle
Check?"
3. [#] or [%] > "6 Registration" > [Yes].
4. For more see "Registration" in "4. Troubleshooting.”
Reset System 1. [Clear Modes]> [107]> [Clear/Stop]> "Service Menu">
[Yes]> "Bit Switch"
2. [#] or [%] > "Reset Settings"> [Yes]> "Initialize Sys.">
[Yes]> "Press Yes Key"> [Yes]
SMC Report See "Engine Summary Chart" above.
SP Mode (Entering) 1. [Clear Mode]> [107]
2. [Clear/Stop]> Hold 3 sec. and release> "Service
Menu"
SP Mode – Changing SP
Codes
1. [Clear Mode]> [107]
2. [Clear/Stop]> Hold 3 sec. and release> "Service"
menu"
3. [#] or [%] > "Engine Maint."> [Yes]
4. For more about changing SP codes, see "Using SP
Mode Menus" in "5. Service Tables2.
Scanning Test 1. [Menu]> [#]> [*]> [Yes]> "1. SERVICE'S CHOICE"
2. [#] or [%] > "6. FUNCTION"> [Yes]> "ADF. FEED
TEST"
3. [#] or [%] > "SCAN TEST"> "[Yes]> "SCAN
TEST/SCAN=START"
4. [B&W Start] to start the test
5. [Clear/Stop] to stop the test
Service Mode Entry
(Controller or
Fax/Scanner/ARDF)
[Menu]> [#]> [*]> [Yes]> "1. SERVICE'S CHOICE"
To Next Page
Loading...
