Service Mode
J012/J013/J014 5-20 SM
7. SOFT SETTING
There are a total of 14 8-bit switches in machine flash ROM, mainly used for PTT regulation.
The "Country Code" selection in the Service Mode determines the default settings. For more
details, please refer to the Facsimile Manual.
Bit SW Quick Reference Table
Here is a quick summary of the software setting bit switches.
Bit SW Function
01 Initial TX selection open to user
02 Detect dial tone before dialing
PSTN/PBX setting
Dial mode select
03 Send tone 1400 Hz 3 sec in fax/tel mode
Force user to register fax no./user name
TSI/CSI append "+"
04 Dial registered limit for tel. no.
Visible alarm for RTN (Return To Negative) signal
05 Redial attempt counter
06 Redial
07 Redial interval
08 Minimum redial interval
Maximum redial interval
09 Continue redial after failure
Redial attempt failure limitation count
10 RX print mode
Header for fax TX
11 Footer
To Next Page
Loading...
