Before Replacing Parts
J012/J013/J014 3-8 SM
To remove: First, remove in this order:
Ink Collector Unit ---
Ink Level Sensor 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Cover
Left Cover 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray
Maintenance Unit 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Cover
Maintenance Unit Motor 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Cover
Network Interface Board ---
Original Pressure Plate 1) Platen or ADF.
PSU 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Left Cover
Paper Cassette, Output Tray ---
Platen (J012) ---
Engine Unit Swap 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Cover, 5) Left Cover, 6)
Scanner Unit
Rear Cover 1) Platen or ADF., 2) Scanner Unit to Full Upright, 3)
Duplex Unit, 4) Paper Cassette, Output Tray, 5) Right
Cover, 6) Left Cover, (6) Scanner Unit
Rear Fan 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Cover, 5) Left Cover, 6)
Scanner Unit, 7) Rear Cover
Right Cover 1) Platen or ADF., 2) Scanner to Full Upright, 3) Right
Front Cover
Right Front Cover ---
To Next Page
Loading...
