Before Replacing Parts
SM 3-9 J012/J013/J014
Replacement
Adjustment
To remove: First, remove in this order:
Right Inner Cover 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Front Cover, 5) Right
Cover
Scanner CTL Board, NCU Swap the Scanner Unit. See "Scanner Unit" in this table.
Scanner Unit 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Right Cover, 5) Left Cover
Note: If scanner unit will be replaced, download address
book data to a computer with the Device Setting Utility.
After replacement upload address book data to new
scanner unit.
Scanner Unit Sensor (Platen
Sensor)
1) ADF., 2) Scanner to Full Upright, 3) Paper Cassette,
Output Tray, 4) Right Front Cover, 5) Right Cover, 6)
Right Inner Cover, 7) Front Cover, 8) Front Cover
Scanner to Full Upright 1) Platen or ADF.
Vertical Encoder Sensor 1) Platen or ADF., 2) Scanner to Full Upright, 2) Paper
Cassette, Output Tray, 3) Left Cover
Vertical Encoder Wheel 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Left Cover
Vertical Motor 1) Platen or ADF., 2) Scanner to Full Upright, 3) Paper
Cassette, Output Tray, 4) Left Cover
To Next Page
Loading...
