Scanner Unit
SM 4-35 M052/M053/M054
Replacement
and
Adjustment
Reinstalling the Front Scanner Wire
1. Position the center ball [A] in the middle of the forked holder.
2. Pass the right end (with the ball) [B] through the square hole. Pass the left end (with the
ring) [C] through the notch.
3. Wind the right end counterclockwise (shown from the machine's front). Wind the left end
clockwise.
The two blue marks [D] come together when you have done this. Stick the wire to
the pulley with tape. This lets you easily handle the assembly at the time of
installation.
To Next Page
Loading...
