Ricoh M052 - Adjusting Blank Margin

Adjusting Copy Image Area
M052/M053/M054 4-6 SM
Adjusting Blank Margin
Use the Trimming Area Pattern (SP2-902-14) for this adjustment.
1. Print out the test pattern.
2. Measure the distance between the four edges of the image area and the four edges of the
paper [A][B][C][D].
 The diagram shows the paper on the copy tray. Note that the paper is output with
the face down.
3. Adjust the blank margin (SP2-101).
SP Specification
SP2-101-001 (Leading Edge) [A] 2 ± 1.5 mm
SP2-101-002 (Trailing Edge) [B] 2 +2.5/-1.5 mm
SP2-101-003 (Left Side) [C] 2 ± 1.5 mm
SP2-101-004 (Right Side) [D] 2 +2.5/-1.5 mm
 The "Left Side" and "Right Side" comes to your left-hand side and right-hand side
respectively when you view the copied image with the leading edge upwards.
4. Specify "0" (zero) in SP2-902-x after finishing the adjustment procedure.
⇒
Rev. 04/10/2012
⇒