Printer Service Mode
SM 5-181 M052/M053/M054
System
Maintenance
Reference
1001 Bit Switch
009 Bit Switch 9 0 1
bit 0
PDL Auto Detection timeout of jobs
submitted via USB or Parallel Port (IEEE
1284).
0: Disable
(Immediately)
1: Enable
(10 seconds)
To be used if PDL auto-detection fails. A failure of PDL auto-detection does
not necessarily mean that the job cannot be printed. This bit switch tells the
device whether to time-out immediately (default) upon failure or to wait 10
seconds.
bit 1 DFU - -
bit 2
Job Cancel
Disabled
(Not
cancelled)
Enabled
(Cancelled)
If this bit switch, all jobs will be cancelled after a jam occurs.
Note: If this bit SW is enabled, printing under the following conditions might
result in problems:
Job submission via USB or Parallel Port
Spool printing (WIM >Configuration > Device Settings > System)
bit 3
to 7
DFU - -
1003 [Clear Setting]
1003 001 Initialize System
Initializes settings in the System menu of the
user mode.
1003 003 Delete Program DFU
To Next Page
Loading...
