Ricoh M052 - Page 418

Firmware Update
M052/M053/M054 5-196 SM
34
Module mismatch - Correct
module is not on the SD
card)
SD update data is incorrect. Acquire the correct
data (Japan, Overseas, OEM, etc.) then install
again.
35
Module mismatch - Module
on SD card is not for this
machine
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.
36
Cannot write module - Cause
other than E34, E35
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.
40
Engine module download
failed
Replace the update data for the module on the
SD card and try again, or replace the BICU
board.
42
Operation panel module
download failed
Replace the update data for the module on the
SD card and try again, or replace the LCDC.
43
Stamp data module
download failed
Replace the update data for the module on the
SD card and try again, or replace the hard disks.
44
Controller module download
failed
Replace the update data for the module on the
SD card and tray again, or replace controller
board.
50
Electronic confirmation check
failed
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.