Ricoh M052 - Page 557

Bit Switches
SM 45 M381
Fax Option
Type SP5200
(M381)
6
Protocol dump list output after
each communication
0: Off
1: On
This is only used for communication
troubleshooting. It shows the content of the
transmitted facsimile protocol signals. Always
reset this bit to 0 after finishing testing.
If system switch 09 bit 6 is at "1", the list is only
printed if there was an error during the
communication.
7 Not used Do not change the setting.
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02 [SP No. 1-101-003]
No FUNCTION COMMENTS
0-1
Not used
Do not change these settings.
2
Force after transmission stall
0: Off
1: On
With this setting on, the machine resets itself
automatically if a transmission stalls and fails to
complete the job.
3
Not used
Do not change these settings.
4
File retention time
0: Depends on User
Parameter 24 [18(H)]
1: No limit (until the year 2126)
1: A file that had a communication error will not be
erased unless the communication is successful.
5
Not used
Do not change this setting.