Bit Switches
SM 47 M381
Fax Option
Type SP5200
(M381)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 [SP No. 1-101-010]
No FUNCTION COMMENTS
0
Addition of image data from
confidential transmissions on
the transmission result report
0: Disabled 1: Enabled
If this feature is enabled, the top half of the first
page of confidential messages will be printed on
transmission result reports.
1
Print timing of communication
reports on the Journal when
no image data was
exchanged.
0: After DCS/NSS
communication (default),
1: After polling
0: Journal is printed only when image data is sent.
1: Journal is printed when any data is sent.
2
Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
3
Printing of the error code on
the error report
0: No 1: Yes
1: Error codes are printed on the error reports.
This can be used for detecting an error which
rarely occurs.
4
Not used
Do not change this setting.
5
Power failure report
0: Disabled 1: Enabled
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when the
power was turned off last.
NOTE: If "0" is selected, no reports are printed
and no one may recognize that fax data is gone
due to a power failure.
To Next Page
Loading...
