Data Overwrite Security Unit Type I (D362)
M052/M053/M054 2-50 SM
10. Make sure that the Data Overwrite icon is displayed in the bottom right hand corner of the
screen.
11. Take a test copy, and then make sure that the Data Overwrite icon changes from “Dirty”
(solid) to “Dirty” (blinking), and then to “Clear”.
Note:
If the Data Overwrite icon does not change to Clear, check to see if there are any active
Sample Print or Locked Print jobs. A Sample Print or Locked Print job can only be
overwritten after it has been executed.
The Dirty icon blinks while an overwrite is in progress.
If you use your machine for a while with Auto Erase Memory disabled, and then
suddenly enable it, the overwrite process may take 10 or more hours depending on
HDD usage.
Data Overwrite icon:
Clear (There is no temporary data to be overwritten)
Dirty (There is temporary data to be overwritten)
Rev. 11/7/2013
To Next Page
Loading...
