Electrical Components
M199/M200/M203/M204 3-86 SM
The default setting is "OFF". Select "ON" only if the customer wants to use this
feature.
17. Select "Registration", and then adjust the registration for each direction (vertical and
horizontal direction) and tray if necessary.
18. Select "2nd Transfer Fuser Tem p", and then adjust the transfer roller bias and the
temperature reduction of the fusing unit for each paper type and for the front and back sides.
The default settings for normal operation are all '0'.
19. Perform “Color Registration” in the “Engine Maintenance” menu.
20. Turn the power off and on.
MUSIC will be performed automatically.
21. Print out the test chart (page 3-25 "Laser Optics Housing Unit"), and make sure that MUSIC
was performed successfully.
If MUSIC is not performed successfully, see “If MUSIC has not been performed
successfully” (page 3-25 "Laser Optics Housing Unit").
22. If necessary, adjust the registration settings for the front and rear sides of each paper tray in
the “Engine Maintenance” menu.
23. Exit "Engine Maintenance".
To Next Page
Loading...
