Ricoh M199 - Waste Toner Bottle Set Sensor

Image Transfer
M199/M200/M203/M204 3-44 SM
3.8.7 WASTE TONER BOTTLE SET SENSOR
1. Rear cover (page 3-6 "Rear Cover")
2. Controller box cover (page 3-63 "Controller Board")
3. Only for MF models: FCU and Speaker bracket (page 3-63 "Controller Board")
4. Disconnect CN315 on the EGB
5. Remove two screws [A] for the waste toner sensor base.
6. Remove all the AIO cartridges. (page 3-32 "AIO Cartridge")
7. Image transfer belt unit (page 3-37 "Image Transfer Belt Unit")
8. Waste toner sensor base [B]
9. Waste toner bottle set sensor [C] (3hooks,
× 1)