Ricoh M199 - Page 142

Firmware Updating
SM 4-27 M199/M200/M203/M204
System
Maintenance
Reference
11. Turn off the power of the machine, and then turn it back on.
12. Print a configuration or maintenance page to check the machine's firmware version.
 Do not turn off the machine until the update completion message appears on the
machine’s control panel. Otherwise, the controller board will be damaged.
 If the update completion message does not appear, the download failed. Try again. You
can also switch from an Ethernet connection to a USB connection and see if that works. If
you still cannot download the firmware, it may be necessary to change the EGB and/or
the controller board.
 If power failed during the download, try again. If you still cannot download the firmware, it
may be necessary to change the EGB and/or the controller board.