When You Cannot Send or Receive Fax Messages As Wanted
29
3
When You Cannot Send or Receive Fax
Messages As Wanted
This section describes likely causes of and possible solutions for transmission
and reception-related problems.
❖ Transmission/Reception
❖ Transmission
Problem Cause Solution
Both transmission and
reception are impossible.
The modular cable may be dis-
connected.
Make sure that the modular cable
is correctly connected. See “Con-
necting the Machine to a Tele-
phone Line and Telephone”,
General Settings Guide.
Both transmission and
reception are impossible.
The terminal adaptor setting is in-
correct.
Check the setting.
Problem Cause Solution
Document appears
blank at the other end.
The original was placed upside
down.
Place it correctly. See “Placing
Originals”, Facsimile Reference.
Transmission failed
due to a “maximum e-
mail size” error.
The size of the Internet fax docu-
ment exceeds the maximum e-
mail size specified on the ma-
chine.
Set [Maximum E-mail Size] under [E-
mail Settings] to [Off], or set the
maximum e-mail size to a larger
value. Then, re-send the docu-
ment. See “E-mail Settings”, Gen-
eral Settings Guide.
LAN-Fax Driver does
not work.
The entered login user name,
password, or driver encryption
key is incorrect.
Check your login user name,
password, or driver encryption
key, and enter them correctly.
Contact the administrator.
LAN-Fax Driver does
not work.
A high security level is set by the
extended security function.
Contact the administrator.
Cannot cancel a Memo-
ry Transmission.
The document is being scanned. Press the {Clear/Stop} key. See
“Canceling a Transmission”, Fac-
simile Reference.
Cannot cancel a Memo-
ry Transmission.
The document is being sent or it is
in standby.
Press the {Clear/Stop} key. See
“Canceling a Transmission”, Fac-
simile Reference.
Cannot cancel an Im-
mediate Transmission.
-Press the {Clear/Stop} key. See
“Canceling a Transmission”, Fac-
simile Reference.
To Next Page
Loading...
Need help?
General