Ricoh P C600 User Manual

Problem Cause Solution
Printing does not start. If the printer is using wireless
LAN, the receiver's MAC
address may be preventing
communication with the access
point.
Check the access point settings
when using the infrastructure
mode. Depending on the access
point, client access may be
filtered by MAC address. Also,
check that there are no
transmission problems between
the access point and wired
clients, and between the access
point and wireless clients.
Printing does not start. The Login User Name, Login
Password, or Driver Encryption
Key is incorrect.
Check the Login User Name,
Login Password, and Driver
Encryption Key.
Printing does not start. Advanced encryption has been
set using the Extended Security
function.
Check the settings of the
Extended Security function. For
details about Extended Security
function settings, see
"Specifying the Extended
Security Functions", Security
Guide.
[List / Test Print] is disabled. A mechanical error might have
occurred.
Contact your service
representative.
Printing does not start when
using the extended wireless
LAN in Ad-hoc Mode.
The correct Communication
Mode is not set.
• Turn the main power switch
off and then back on
again. For details about
how to turn on/off the
main power switch, see
page 35 "Turning On/Off
the Power".
• Change [Communication
Mode] in [Host Interface]
to [802.11 Ad-hoc
Mode], and then select
[Off] for [Security
Method]. For details about
Communication Mode, see
"Host Interface",
Operating Instructions.
When You Cannot Print
95

Ricoh P C600 Specifications

General

Type	Original
Printing colors	Black
Quantity per pack	1 pc(s)
Built-in drum unit	-
Brand compatibility	Ricoh
Black toner page yield	18000 pages
Print technology	Laser printing

Weight and Dimensions

Package type	Box
Package weight	379 g