On Hook Dial
17
3
On Hook Dial
You can send a fax message without
lifting the receiver, while still listen-
ing to the dial tone.
If the other party has a telephone fax
machine, you can talk by lifting the
receiver after your machine has con-
nected to theirs.
Reference
See Chapter 4 “Adjusting Volume”
in the Basic Features manual.
A
AA
A
Place your original, and then se-
lect any scan settings you require.
B
BB
B
Press the {
{{
{On Hook Dial}
}}
} key.
You will hear a tone from the inter-
nal speaker. If you wish to cancel
this operation, press the {
{{
{On Hook
Dial}
}}
} key again.
C
CC
C
Dial.
The machine immediately dials the
destination. If you make a mistake,
press the {
{{
{On Hook Dial}
}}
} key and re-
turn to step B.
Note
❒ You can change the volume of
sound with 0 or 1.
D
DD
D
When the line is connected and
you hear a high-pitched tone,
press the {
{{
{Start}
}}
} key.
When the originals are placed on
Document Feeder (ADF), the ma-
chine starts transmitting the origi-
nals. The display will be that
shown for step F.
Note
❒ If you hear a voice, pick up the
external telephone before you
press the {
{{
{Start}
}}
} key and notify
the destination that you want to
send a fax message (ask them to
switch to Facsimile mode).
E
EE
E
When the originals are not placed
on the Document Feeder, press 0
00
0
or 1
11
1 to select "Send".
F
FF
F
Press the {
{{
{OK}
}}
} key.
The originals are transmitted.
After transmission, the machine
will return to standby mode.
StellaCEN-advanced_V4_FM.book Page 17 Tuesday, July 17, 2001 1:01 PM
To Next Page
Loading...
