Troubleshooting
36
3
When Memory Is Full
Messages Causes Solutions
Memory is full. [Print] scanned
orig., [Clear] to cancel/clear
memory.
[Clear][Print]
Note
❒ Copying will stop and this message will be
displayed when the memory is full.
The scanned original
exceeds the number
of pages that can be
stored in memory.
Press [Print] to copy
scanned originals
and cancel the scan-
ning data. Press
[Clear] to cancel the
scanning data and
not copy.
Reset * orig., then press
[Resume] to scan and copy the re-
maining originals.
[Stop] [Resume]
The machine checks
if the remaining orig-
inals should be cop-
ied, after the scanned
original has been
printed.
To continue copying,
remove all copies,
and then press
[Resume]. To stop
copying, press [Stop].
StellaC2_GBcopy_F1_pre_FM.book Page 36 Tuesday, December 16, 2003 4:39 PM
To Next Page
Loading...
