Service Program Mode
64
3
120 User Code Mode Selects user code mode. When you set this function,
you have to also specify the auto reset time. For de-
tails about user code mode, see ⇒ P.66 “User Codes”.
Note
❒ Default:
• User Code mode: 0
• Auto Reset time: 0
❒ Adjustment value:
• User Code mode: 0: No 1: Yes
• Auto Reset time: 0: No, 1 – 5 minutes
121 UC Count Displays the number of masters and prints made in
each user code.
Note
❒ M: Number of masters
❒ P: Number of prints
122 Clear UC Count Clear each user code counter.
Note
❒ Default: 0
❒ Adjustment value: 0: No 1: Yes
123 Total UC Count Display the total number of masters and prints for all
the 20 user codes.
Note
❒ M: Number of masters
❒ P: Number of prints
124 Clear Total UC
Count
Clear the total user code counter.
Note
❒ Default: 0
❒ Adjustment value: 0: No 1: Yes
125 Auto Energy Saving You can set the time until the Energy Saver mode
starts.
Note
❒ Default: 3 Min. (minutes)
❒ Adjustment value: 0: No, 1 – 120: Min
SP No. Mode Function
SilverV-gb.book Page 64 Monday, May 15, 2000 3:32 PM
To Next Page
Loading...
