Master Roll Replacement
77
4
Master Roll Replacement
The Master End indicator (C) is lit
when it is time to replace the master
roll.
A
Open the original tray.
Note
❒ Lift the original tray release le-
ver and lift the original tray.
B
Open the right side cover.
C
Open the plotter cover.
D
Remove the used master roll and
pull out both spools. Then, insert
both spools into a new master
roll.
Note
❒ When the Master End indicator
lights, it is necessary to replace
the master roll even if some
master remains on the old roll.
E
The new master roll must be posi-
tioned as shown in the illustra-
tion.
TSLH01SE
TSLH02EE
TSLT010E
TSLH01XE
SilverV-gb.book Page 77 Monday, May 15, 2000 3:32 PM
To Next Page
Loading...
